Before Startup - Kärcher SE 4002 Mode D'emploi

Attachment for wet/dry vacuuming
25 Attachment for wet/dry vacuuming
26 Floor nozzle with hard surface insert
27 Crevice nozzle
28 Upholstery nozzle
29 Filter bag

Before Startup

Illustration
 Remove the fresh water reservoir.
Press the release and remove the tank.
Note: The motor casing can only be re-
moved if the fresh water reservoir was
removed first.
Illustration
 Remove the motor casing. For this,
fold the carrying handle forward to un-
latch the reservoir. Remove the acces-
sories and swivel casters from the
reservoir.
Illustration
 Turn the container, press in the swivel
casters in the openings at the base of
the container till the end-point.
Illustration
 Turn the motor casing around and at-
tach the foam filter to the filter basket.
 Insert the filter cover and turn to lock.
 Install the motor casing. Pull up on
the carrying handle to lock.
Illustration
 Install the fresh water reservoir. In-
sert the bottom part first and then press
toward the top on the motor compart-
ment to check if it is locked in.
Illustration
 Attach the suction hose and the spray
hose to the connectors on the appli-
ance.
Note: Press the suction hose tightly into
the connector to lock it into place.
Illustration
 Connect the spray/suction pipes and at-
tach to the handle. Center the locking
lever when attaching it, turn clockwise
to lock.
16
 Attach the floor nozzle to the spray/suc-
tion pipes and secure with locking lever.
The appliance is now prepared for wet
cleaning.
Always work with an inserted foam
filter - during wet as well as dry vac-
uum cleaning!
Wet cleaning of carpets/hard
surfaces/upholstery
Health risk, risk of damage!
Check the object to be cleaned prior to us-
ing the appliance in an inconspicuous place
for colour fastness and water resistance.
Do not clean water-sensitive floor cover-
ings such as wood floors (the moisture
could penetrate and damage the floor).
Note
Warm water (max. 50°C) will increase the
cleaning effect.
Wet cleaning of carpeted floors
 Use the wash floor nozzle.
 Work without the hard surface insert.
Please only use the carpet cleaner RM 519.
Wet cleaning of hard surfaces
 Use the wash floor nozzle.
 Slide the attachment for hard surfaces
onto the spray ex floor nozzle from the
side. The bristles should point towards
the back.
Wet cleaning of upholstery
 Use the wash hand nozzle.
Fill up fresh water reservoir
Note: You can remove the water reservoir
to fill it or you can fill it directly on the appli-
ance.
Illustration
 Flip the reservoir cover up.
 Add 100 - 200 ml (volume depends on
degree of contamination) of RM 519
into the fresh water reservoir, then add
tap water - do not overfill.
 Close the reservoir cover.
– 8
EN
Operations