Description Of The Appliance; Before Startup - Kärcher A 2656 X plus Mode D'emploi

Caution
Certain materials may produce explosive va-
pours or mixtures when agitated by the suc-
tion air!
Never vacuum up the following materials:
Explosive or combustible gases, liquids
–
and dust particles (reactive dust particles)
Reactive metal dust particles (such as
–
aluminium, magnesium, zinc) in combina-
tion with highly alkaline or acidic deter-
gents
Undiluted, strong acids and alkalies
–
Organic solvents (such as petrol, paint
–
thinners, acetone, heating oil).
In addition, these substances may cause the
appliance materials to corrode.

Description of the Appliance


When unpacking the product, make sure
that no accessories are missing and that
none of the package contents have been
damaged. If you detect any transport
damages please contact your dealer.

The basic suction device is mounted on a
chassis and can be detached, for e.g. for
emptying or for transporting in a car.
Note: Please refer to page 2 for figures of the
appliance and the operation.
Illustration
1 Chassis with wheels and castors
2 Transport handle; height can be adjusted
in two phases
3 Accessory mount
4 Unlock basic suction device
5 Container
6 Parking brake
7 Motor casing
8 Carrying handle
9 Blowing connection
10 Air regulation of the blowing function
11 ON/OFF switch for appliance
12 Power cord with plug
13 Storage, power cord
14 Suction hose connection
15 Filter bag
8
Accessories
ø 35 mm
16 Suction hose
(A) Manual vacuum slide
17 Suction tubes 2 x 0.5 m
18 Floor nozzle, reversible
19 Crevice nozzle
Accessories
ø 60 mm
20 Suction hose
21 Suction tubes 2 x 0.5 m
22 Coarse dirt nozzle
Always work with an inserted car-
tridge filter - during wet as well as
dry vacuum cleaning!
All accessories are suitable for wet vacuum-
ing as well as for dry vacuuming.
The accessories with a nominal width of 35
mm are intended for normal appliactions.
Please use the accessories with a nominal
width of 60 mm for appliactions with coarse
dirt.

Before commissioning, it is necessary to
install the steering rollers, the handle and
the wheels with axis on the chassis.
The chassis needs to be assembled
only once; instructions for the same
are described on an enclosed sheet.
Illustration

Connect accessories.
Illustration

Plug in the main plug.
Illustration

Switch on the appliance using the ON/
OFF switch.
Illustration

To move the device, first place one foot on
the ground, hold it and pull the transport
handle backwards.
- 2
EN
Operation

Before Startup

Start up