Struers Transpol-2 Mode D'emploi page 3

Transpol-2
Instruction Manual
Transpol-2
Safety Precaution Sheet
To be read carefully
before use
1. The operator should be fully aware of the use of the apparatus
according to the Instruction Manual.
2. If grinding accessories not recommended by Struers are used, they
must be approved of for speeds above 8500 rpm. Do not use grinding
stones with diameter larger than 10 mm.
3. Make sure that the current-carrying parts are kept in order. If any
damage to a cable has been observed it must be corrected
immediately.
4. Use an isolating transformer in wet and moist rooms.
5. Always use safety goggles when working with Transpol-2.
6. Always protect the motor and control unit from rain and moisture.
7. The grinding unit must not be used without reduction gear.
8. Always clamp the grinding tools carefully.
The equipment is designed for use with consumables supplied by Struers. If subjected to misuse, improper
installation, alteration, neglect, accident or improper repair, Struers will accept no responsibility for
damage(s) to the user or the equipment.
Dismantling of any part of the equipment, during service or repair, should always be performed by a qualified
technician (electromechanical, electronic, mechanical, pneumatic, etc.).