Coarse Grinding; Grinding And Fine Grinding - Struers Transpol-2 Mode D'emploi

Coarse Grinding

Grinding and Fine Grinding

Transpol-2
Instruction Manual
Screw the straight handle on the reduction gear in the same way
as the reduction gear was mounted on the motor.
Place the flapper wheel in the handle, put the lock pin in the hole
in the middle of the handle and fasten the flapper wheel in the
handle with the spanner.
Switch the mains switch to ON. The display will light up.
Press the Start/ Stop button and the motor starts rotating.
Adjust the speed as required. Coarse grinding with flapper wheel
requires the highest speed.
Dismount the straight handle (the reduction gear must remain
mounted on the motor).
Mount the right angle handle and tighten it with the spanner in
the same way as the reduction gear was mounted on the motor.
Place the rubber disc in the quick coupling device of the right
angle handle.
Hold back on the angle head with your thumb and at the same
time turn the rubber wheel and press it into place.
Take a piece of grinding paper with the appropriate grit size.
Remove the cover paper at the rear and press the grinding paper
against the rubber disc with your thumb.
Normally, grinding is carried out in 4 steps
(grit 60, 120, 240, 500).
5