Spare Parts - Franke medi-Flo HWSS2321W Mode D'emploi

EN
15
Re-connect the blue band power
connection between the ozone generator and
the programmable control board.
16
Re-connect the 3/8" tubing water
supply connection and open the shut off valve.
17
Plug in the power and wait 20 seconds
before activating.
18
Actuate the sink by waving your hand
in front of the IR sensor. Keep your hand in-
front of the sensor until water begins flowing
into the sink. At this point look actuate the
sink while looking at the ozone generator.
If operating correctly, you will see bubbles
flowing from the ozone generator into the
canister.

SPARE PARTS

13
Solenoid Valve
1
#2000104454
Ozone Interface Control Unit
3
#AT00-141
14
OZONE GENERATOR TECHNICAL INFORMATION
The ozone generator within Medi-flo not only generates ozone but also other powerful oxidants
such as oxygen atoms, (O
destroy harmful bacteria and viruses.
06/17 HWSS2321W-00 | 2030030464
HWSS2321W-00
), hydrogen peroxide and hydroxyl radicals which all work together to
2
19
Adjust the shut off valve so that the
water is in the target area shown below.
20
Re-assemble the shroud.
Mixing Valve #MIX-LF
2
Programmable IR Sensor
4
#AT00-142
11