Franke medi-Flo HWSS2321W Mode D'emploi page 7

EN
TESTING
8
a. Ensure that all plumbing lines have been properly flushed. If lines are not properly flushed,
it can clog the check stops in the mixing valve and/or clog the strainer in the input side of
the solenoid valve. This can result in low water flow.
b. Please note, the output side of the solenoid valve contains a pressure regulator. The water
lines MUST be purged of all air prior to sink operation. Otherwise it can cause the water
stream to spit out of the orifice causing water to spray outside the sink.
c. With system flushed and pressurized, place your hand in-front of the IR sensor inside the
sink bowl. You will hear the solenoid valve open and water will begin to run.
d. Holding your hand in front of the sensor, you will see ...
i.
ii. the LED will be illuminated (seen from the spout), and
iii. the ozone generator will be active. You will also see bubbles coming from the ozone
generator into the water.
e. If you have high pressure conditions, the shut off valve can be used to slightly reduce the
stream length. Adjust as necessary
so that when the water targets this
range when running. Cycle the sink
multiple times until consistent.
f. Hold your hand in the target area to
make sure water triggers. Depending
on local lighting conditions, sensor
sensitivity may need to be adjusted.
This can be
done using
the wireless
handheld
programmer
AC05-001.
If any of the above is not functional, double
check that the connections are colour matched and that the connection is made properly.
Normal operation is as follows:
- IR sensor will see a users hand.
- This will trigger the water flow, LED
and the ozone generator will turn on.
- When the user removes their hands to lather, the water flow and LED will turn off however
the ozone generator will stay on for 20 seconds (unless programmed otherwise). After the
20 seconds the water flow will trigger by itself for 3 seconds. This is done to help signal the
user of the 20 second minimum lather time and also for a subsequent wash rinse of the sink.
Once the sink is operating properly, final leveling may occur. Ensure that the water stream hits
the center of the water dispersion rib that runs along the sink bowl front to back. When this is
achieved, tighten down wall bracket hardware and secure lower mounting holes with either the
supplied hardware included with the IWC2104 wall carrier (or appropriate hardware if installing
06/17 HWSS2321W-00 | 2030030464
water entering the clear laminar flow chamber,
HWSS2321W-00
7