Franke medi-Flo HWSS2321W Mode D'emploi page 5

EN
INSTALL THE WASTE FITTING INTO THE SINK.
5
a. Disassemble the waste fitting.
b. Slide the waste body and upper gasket into the sink hole.
c. Slide the lower gasket, paper washer and thread the lock nut onto the body.
d. Tighten into place.
e. Insert the tailpiece with the overflow port into the tailpiece nut.
f. Insert the tailpiece washer into the overflow port.
g. Tighten the tailpiece assembly onto the waste body. Aim the bypass port to the rear of the sink.
h. Insert the bypass hose (coming from the outlet port of the sink) into the bypass port hole.
(using a little bit of hand soap on the outside of the tube will help in insertion).
i. Connect the trap (provided by others).
06/17 HWSS2321W-00 | 2030030464
BYPASS PORT
HWSS2321W-00
REMOVABLE CAP
WASTE BODY
UPPER GASKET
LOCK NUT
TAILPIECE GASKET
TAILPIECE NUT
5