Grain Size; Starting Operation - Bosch GSS 140 A Professional Notice Originale

All manuals and user guides at all-guides.com
OBJ_BUCH-634-001.book Page 9 Thursday, June 5, 2008 7:55 AM
Replacing the Sanding Sheet
When attaching a new sanding sheet, remove any
dust or debris from the sanding plate 2 (e. g. with
a brush).
To ensure optimum dust extraction, pay atten-
tion that the punched holes in the sanding sheet
match with the holes in the sanding plate.
Sanding Sheets without Velcro Backing
(see figures C–E)
Press the release button 5 and keep it
pressed.
Guide the sanding sheet 4 to the stop under
the opened front clamping bracket 6 and let
go of the release button 5 again. Pay atten-
tion that the sanding sheet is clamped cen-
trally.
Press the sanding sheet clamp 3 inward and
pivot it to the stop.
Fold the sanding sheet 4 firmly around the
sanding plate. Guide the other end of the
sanding sheet 4 between the rear clamping
bracket and the red roller on the clamping
bracket 3.
Hold the sanding sheet tensely and press the
clamping bracket 3 toward the sanding plate
to lock the sanding sheet.
Sanding sheets without holes, e. g. from rolls or
by the meter, can be punctured with the perfo-
rating tool 11. For this, push the power tool with
the sanding sheet mounted onto the perforating
tool (see figure F).
To remove the sanding sheet 4, loosen the clamp-
ing bracket 3 and pull out the sanding sheet from
the rear holding fixture. Press the release button
5 and completely remove the sanding sheet.
Sanding Sheets with Velcro Backing
Sanding plates 2 fitted with Velcro backing can
be used to fasten sanding sheets with Velcro ad-
hesion quickly and easily.
Before attaching the sanding sheet 4, free the
Velcro backing of the sanding plate 2 from any
debris by tapping against it in order to enable op-
timum adhesion.
Bosch Power Tools
Position the sanding sheet 4 flush alongside one
edge of the sanding plate 2, then lay the sanding
sheet onto the sanding plate and press it against
it with a light turning motion in clockwise direc-
tion.
To remove the sanding sheet 4, grasp it at one of
the tips and pull it off from the sanding plate 2.
Selecting the Sanding Sheet
Depending on the material to be worked and the
required rate of material removal, different sand-
ing sheets are available:

Grain size

For working all wooden
materials
For coarse sanding, e. g. of
rough, unplaned beams
and boards coarse
For face sanding and plan-
ing small irregularities medium 80, 120
For finish and fine sanding
of hard woods fine
For working paint/enamel
coats or primers and fill-
ers
For sanding paint off coarse
For sanding primer medium 80, 120
For final sanding of prim-
ers before coating fine
Operation

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the type plate of the
power tool.
1 609 929 N39 | (5.6.08)
English | 9
40 — 240
40, 60
180, 240
40 — 240
40, 60
180, 240