Specific Functions - STERWINS UP20 Notice De Montage - Utilisation - Entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
• Never run the product without the proper equipment attached.
• Do not modify the product in any way or use parts and accessories that are not
recommended by the manufacturer.
If the product is dropped, suffers heavy impact or begins to
vibrate abnormally, immediately stop the product and
inspect for damage or identify the cause of the vibration. Any
damage should be properly repaired or replace by an
authorized service centre.
• To reduce the risk of injury associated with contacting rotating parts, always stop the
machine, remove the battery pack, and make sure all moving parts have stopped:
- before cleaning or clearing a blockage
- when leaving the product unattended
- before installing or removing attachments
- before checking, maintaining or working on the product
- if the machine starts to vibrate abnormally (inspect immediately)
- after striking a foreign object to inspect the machine for damage;
Blowing
Before operation, loosen leaves that are stuck to the ground using a broom or rake.
Hold the tube approximately 10 cm above the ground and walk slowly forward using a sweeping motion
from side to side. While working, ensure that the product does not strike hard objects, as this can cause
damage. Use the full blower nozzle extension.
Removing and charging the battery
1. Press the lock button on the top center of the battery to slide it out of the blower.
2. Place the battery pack into the charger by sliding it into a locked position until it clicks
3. When the green light is flashing, the battery is charging. If the green light is no longer flashing, the
battery is fully charged.

4.5 SPECIFIC FUNCTIONS

This power-tool is not equipped with vaccum or crusher function.
5. TRANSPORTATION
Transporting the machine or battery may require that you meet certain requirements specific to your
country. Please make sure to respect them by contacting the authorities of your country, in order to
respect them all. Ensure temperature during transportation will never be out of temperature range given
on chapter storage
5.1 TRANSPORT THE MACHINE
Switch the product off and remove the battery pack. Remove two tubes from the main unit if necessary.
Always carry the product by its handle. Protect the product from any heavy impact or strong vibrations
which may occur during transportation in vehicles. Secure the product to prevent it from slipping or
falling over. Do not expose the product to sunlight.
5.2 TRANSPORT THE LITHIUM BATTERIES
Please refer to the battery instruction manual for further details.
193
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

20vbl2-gt.1

Table des Matières