End Of Life - STERWINS UP20 Notice De Montage - Utilisation - Entretien

Problems
Battery is not secure
Battery is not charged
Power/speed switch is in the
Product does
not start
Tubes are not correctly
Battery pack not properly
On/off switch not set on ON
Battery pack capacity too
Product does
not reach full
power
Air vents are blocked
Result is Nozzle not properly
unsatisfactory
Nozzle not properly
Vibration
or noise is
excessive
Bolts/nuts are loose
Battery pack discharged
Product
suddenly stops

9. END OF LIFE

Electrical products should not be discarded with household products. Used electrical products
must be collected separately and disposed of at collection points provided for this purpose.
Talk with your local authorities or dealer for advice on recycling.
Probable causes
OFF position
installed
attached
position
low
assembled
assembled
Battery too hot
197
Solutions
To secure the battery pack,
make sure the latches on the
top of the battery pack snap
into place
Charge the battery pack
according to the instructions
included with your model
Press the on/off switch
Check tubes to ensure that
they are allowing the switch
to be engaged when correctly
installed
Attach properly
Refer to chapter "Start the
product"
Charge battery pack
Clean the air vents
Refer to chapter "Attaching/
Removing the tube "
Refer to chapter "Attaching/
Removing the tube "
Tighten bolts/nuts
Remove and charge battery
pack
Remove battery pack and let it
cool down
Qualification
required
No specific
qualification is
required
No specific
qualification is
required
No specific
qualification is
required
No specific
qualification is
required
No specific
qualification is
required
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN