FR
• Use of hearing protection reduces the ability to hear warnings (shouts or alarms).
The operator must pay extra attention to what is going on in the work area. Do not get
distracted, and always concentrate on the task.
ES
• Operating similar tools nearby increases both the risk of hearing injury and the potential
PT
for other persons to enter your work area.
• Keep fi rm footing and balance.
IT
• Do not overreach. Overreaching can result in loss of balance. Always be sure of the
footing on slopes.
EL
• Walk, never run. Keep all parts of your body away from any moving part.
• Never run the product without the proper equipment attached.
PL
• Do not modify the product in any way or use parts and accessories that are not
recommended by the manufacturer.
RU
KZ
UA
RO
BR
• To reduce the risk of injury associated with contacting rotating parts, always stop the
machine, remove the battery pack, and make sure all moving parts have stopped:
EN
- before cleaning or clearing a blockage
- when leaving the product unattended
- before installing or removing attachments
- before checking, maintaining or working on the product
- if the machine starts to vibrate abnormally (inspect immediately)
- after striking a foreign object to inspect the machine for damage
Blowing
Before operation, loosen leaves that are stuck to the ground using a broom or rake.
Hold the tube approximately 10 cm above the ground and walk slowly forward using a sweeping motion
from side to side. While working, ensure that the product does not strike hard objects, as this can cause
damage. Use the full blower nozzle extension.
Removing and charging the battery : Illustration 6.1 and battery instruction manual
1. Press the lock button on the top center of the battery to slide it out of the blower.
2. Place the battery pack into the charger by sliding it into a locked position until it clicks
3. When the green light is fl ashing, the battery is charging. If the green light is no longer fl ashing, the
battery is fully charged.
4.5 SPECIFIC FUNCTIONS
This power-tool is not equipped with vaccum or crusher function.
If the product is dropped, suff ers heavy impact or begins to
vibrate abnormally, immediately stop the product and
inspect for damage or identify the cause of the vibration. Any
damage should be properly repaired or replace by an
authorized service centre.
232