Removing The Hob - Inventum IKE6010RVS Mode D'emploi

BUILDING - IN THE HOB
• Check whether the kitchen unit and the opening conform to the requirements in respect of measurements and
ventilation.
• Remove any wood shavings after the cutting work in the worktop opening and treat the cut edges of plastic or wooden
worktops with sealing varnish if necessary to prevent the worktop from swelling due to moisture.
• Lay the hob upside down on the worktop.
• Fit the connection cable to the hob in accordance with the set requirements.
• Fit the supplied A-clamps in the hob using the supplied screws.
Fitting option A is based on a 38-mm worktop and fitting option B is based on a 28-mm worktop.
• For a thin worktop, we recommend placing extra wooden blocks to enable the clamps to be firmly fitted.
• Turn the hob over and lay it in the opening.
• Connect the hob to the mains supply. The hob is now ready for use.
• Check the operation.
A
1
1. Worktop
2. Screw
3. A-clamp
4. Hob
5. Sealing the hob
260

REMOVING THE HOB

Disconnect the appliance from the power supply. Remove the A-clamps and then remove the hob by exerting pressure
from underneath. Attention! Take care not to damage the appliance! Try not to remove the hob by levering it out of the
worktop from above.
22
• English
5 4
2 3
560
120
520
B
1
1. Worktop
2. Screw
3. A-clamp
4. Hob
5. Sealing the hob
6. Wooden block
260
5 4
15
6 2 3
560
95 50
520