Care And Cleaning; Replacing The Fill Valve; Adjusting The Water Level - Toto CST436 Manuel D'installation Et D'utilisation

Masquer les pouces

Table des Matières

Les langues disponibles

Use a detergent or non-abrasive toilet cleaner and a soft bristled

plastic brush to clean your toilet. To remove hard water stains, use

vinegar or lime dissolving cleaner and a non-scratch scour pad made

for porcelain. Allow a little contact time to allow the cleaner to dis-

solve the buildup.

NOTICE

DO NOT USE IN-TANK BOWL CLEANERS.

The use of high concentration of chlorine or chlorine-related products can

seriously damage fittings in the tank. This damage can cause leakage and

property damage. TOTO shall not be responsible or liable for any tank fitting

failure or damage caused by the use of in-tank bowl cleaners.

1. Shut off the water supply. Flush the toilet and

remove any remaining water from the tank. Reverse

the tank installation instructions to remove it from

the bowl. Remove the refill tube from the overflow

tube and fill valve. Note the orientation of the fill

valve. Remove the old fill valve.

2. Install new fill valve by sliding the threaded portion

of the shaft through the hole in the bottom of tank.

3. Thread mounting nut onto exposed shaft under the

tank and tighten nut. Check fill valve orientation.

⚠CAUTION

Do not over-tighten.

4. Connect the water supply (Ill. 1). Pipe dope is not recommended. Attach the

refill tube to the fill valve and clip the other end to the overflow pipe.

Refer to the water level line stamp inside the tank.

1. The water level adjustment is located in the top

end of the fill valve. Use a flathead screwdriver to

make adjustments:

•

To raise the water level: turn the screwdriver

clockwise, or towards the '+' indicator.

•

To lower the water level: turn the screwdriver

counter-clockwise, or towards the '-'

indicator.

2. Flush after each adjustment to check the water

level. When satisfied with the water level, flush

once more to verify.