Care And Cleaning - Toto CST703X.10 Manuel D'installation Et D'utilisation

Masquer les pouces

Table des Matières

Les langues disponibles

6) Thread mounting nut onto fill valve shank and tighten the nut.

N OTE: Do not over-tighten. Be sure to install fill valve in a position that does not

interfere with the trip lever operation.

7) Connect water supply to fill valve shank and hand-tighten only.

NO TE: Do not overtighten. These are plastic parts. Never use pipe dope on any

water supply connection.

8) Attach refill tube to fill valve nipple and clip other end of refill tube to the overflow

pipe.

9) Turn water supply ON and check for leaks outside the tank.

NO TE: As water fills the tank, water is also directed into the overflow tube via the

refill tube. This additional flow of water is critical to refilling your toilet's bowl.

Once the water stops filling the tank, some residual drops of water may drip

from the fill valve. This is NORMAL as these drops will subside.

Depending on the manufacturing plant, you may have one of two of the following fill

valves:

For Type A Fill Valve:

Refer to the water level (WL) setting

marked on the inner wall of the tank. Allow

the water to fill the tank. Turn the adjust-

ment screw clockwise in the (+) direction to

increase the water level height (see Illustra-

tion 1). Turn the adjustment screw counter-

clockwise in the (-) direction to decrease

the water level height. Flush the toilet to

verify the correct water level. Adjust as

necessary.

For Type B Fill Valve:

There are no water level adjustments. The

fill valve has been preset at the factory.

WARNING!

DO NOT USE IN-TANK BOWLCLEANERS. The use of high concentration of chlorine

or chlorine-related products can seriously damage fittings in the tank. This damage

can cause leakage and property damage. TOTO

for any tank fitting failure or damage caused by the use of in-tank bowl cleaners.

Replacement Procedure (continued)

Water Level Adjustment

Type A