Care And Cleaning - Toto CST405F Manuel D'installation Et D'utilisation

Fill Valve Servicing Instructions (continued)
5. Lift out the center tube as shown
(see Ill. 4).
6. Remove the strainer from the center
tube as shown (see Ill. 5). Clean the
strainer and cap by rinsing them off
under a faucet.
7. Carefully reassemble the valve in the
reverse order.
IMPORTANT
Note the position of the cap when it's
properly assembled to the body. The
ribs on the cap are in line with the float
chamber and the refill port is aligned as
shown (see Ill. 6).
Flush Valve Servicing Instructions
1. Turn off water supply and flush the toilet.
2. Remove the tank lid and place it upside down on a
clean surface.
3. Note the orientation of the flush valve for
reassembly.
4. Turn the upper half of flush valve counter-clockwise
and pull it up to remove it (see Ill. 1).
5. Remove the clear rubber seal gasket and rinse
under running water to clean (see Ill. 2).
6. Place the gasket back on the flush valve (see Ill. 3).
7. Install the flush valve back on the base.
8. Rotate the flush valve so that the white button is on
the left and the blue button is on the right.
9. Carefully, install the tank lid back on the tank.
10. Flush the toilet several times using each push but-
ton to verify proper operation. Check for leakage.
WARNING!
DO NOT USE IN-TANK BOWLCLEANERS. The use of high concentration of chlorine
or chlorine-related products can seriously damage fittings in the tank. This damage
can cause leakage and property damage. TOTO
for any tank fitting failure or damage caused by the use of in-tank bowl cleaners.

CARE AND CLEANING

10
Ill. 5
Ill. 6
RIBS IN LINE
WITH FLOAT
CHAMBER
RIBS
Ill. 1
Ill. 2
Ill. 3
shall not be responsible or liable
®
REFILL PORT
FLOAT
CHAMBER