Water Level Adjustment; Flush Valve Servicing Instructions; Care And Cleaning - Toto CST484CEMF Manuel D'installation Et D'utilisation

9. Attach refill tube to fill valve nipple and clip other end of refill tube to the over-
flow pipe.
10. Turn water supply ON and check for leaks outside the tank.
NO TE: As water fills the tank, water is also directed into the overflow tube via the
refill tube. This additional flow of water is critical to refilling your toilet's bowl.
Once the water stops filling the tank, some residual drops of water may drip from
the fill valve. This is NORMAL as these drops will subside.
Refer to the water level (WL) setting marked on
the inner wall of the tank. Allow the water to fill
the tank. Turn the adjustment screw clockwise
in the (+) direction to increase the water level
height (see Illustration 1). Turn the adjustment
screw counter-clockwise in the (-) direction
to decrease the water level height. Flush the
toilet to verify the correct water level. Adjust as
necessary.

FLUSH VALVE SERVICING INSTRUCTIONS

1. Turn off the water supply and flush the toilet.
2. Remove the tank lid and place it upside down on a
clean surface.
3. Turn upper half of valve counter clockwise and pull out
the flush valve.
4. Pull the rubber seal gasket sideways to remove from
the flush valve.
5. Rinse under running water to clean.
6. Remove the rubber seal gasket and rinse under run-
ning water to clean.
7. Place the gasket back on the flush valve.
NOTE: Be sure to twist and secure tightly to the base.
8. Install the flush valve back on the base.
9. Carefully, install the tank lid back on the tank.
10. Flush the toilet several times to verify proper operation
11. Check for leakage.
WARNING!
DO NOT USE IN-TANK BOWL CLEANERS.
The use of high concentration of chlorine or chlorine-related products can seriously
damage fittings in the tank. This damage can cause leakage and property damage.
TOTO shall not be responsible or liable for any tank fitting failure or damage caused
by the use of in-tank bowl cleaners.
Installation Procedures (continued)

WATER LEVEL ADJUSTMENT

CARE AND CLEANING

Ill. 1
Water
Level
7
Top of
Overflow
Tube