Troubleshooting; Bathtub Maintenance - Aqua Nova Wellis Notice D'utilisation

TROUBLESHOOTING

If you experience any malfunctions, please take a look at the sheet below before contacting a repairman:
1. The pump is not starting:
Incorrect power supply
The thermal trip switch was activated
The vacuum tube slipped off of the pneumatic
switch or the engine
No power supply
The pump is stuck
2. The pump is not carrying water:
There is not enough water in the system
3. Insufficient water flow, the pump is noisy:
The jets are closed, the pipes are blocked

BATHTUB MAINTENANCE

About once a month, clean the bottom side of the showerhead with a soft brush. This will ensure proper operation
of the showerhead. If there are limescale deposits on the showerhead, wash it with lukewarm vinegar-water. Do not
use abrasive materials (e.g. scouring powder) or corrosive chemicals (e.g. thinners, acetone, hydrochloric acid, or
any derivatives of these) when performing maintenance. The manufacturer accepts no liability for damages due to
improper cleaning. The only proper way to perform cleaning is to use dedicated cleansing products.
Bathtub body and front and side covers
Wipe the surface with a damp cloth. Always use a neutral detergent (not abrasive) and a soft cloth. Do not scratch
the acrylic surface with an abrasive tool, blade or knife, as this may result in damage. Do not use nail polish remover,
acetone, or paint remover when cleaning the surface, as this may cause damage.
→ The voltage of the power grid and the engine must be equal.
→ Try starting the unit in a few minutes. If you are unsuccess-
ful, contact a service center!
→ Check and put back the thin silicone tube onto the engine
or switch.
→ Check to see if it is on.
→ Contact a service center!
→ The water level must reach over the jets, but should be bel-
ow the overflow
→ Clean the system with a pipe disinfection system
27