Faucet; Operating A Bathtub Equipped With A Hydraulic System - Aqua Nova Wellis Notice D'utilisation

4. Flare connection
During transportation, the flare connections found at the engine connections may become loose. Check them
before using the product!
When transporting or moving hydro massage bathtubs with a bubble bath function test the bubble bath system,
then remove the flare connection, so that no water remaining in the pipes may reenter the engine. Reattach the
flare connection before operating the product!
FAUCET (OPTIONAL)
Wellis faucets are only to be used with drinking water and hot water systems!
Technical conditions:
Supply pressure must be between 1 and 5 bars! If the supply pressure is over 5 bars, you must install a pressure relief
valve!
Maximum hot water temperature: 80 °C
Recommended hot water temperature: 65 °C
Faucets must be installed and set up by qualified professionals!
Installation certified by a qualified professional is required for guarantee claims to be valid!
We recommend installing a fine filter into the water system in order to avoid pollutants entering the system, thus
maintaining the integrity of the faucet!
The warranty does not cover damages caused by limescale deposits!
If we find any signs of pollution inside the product during a repair of the faucet, the warranty is considered void!

OPERATING A BATHTUB EQUIPPED WITH A HYDRAULIC SYSTEM

Adjust the temperature and fill the bathtub with water!
The bathtub must be filled with water 2 cm over the upper edge of the upmost jet! Turn the pump on using the pneu-
matic or electrical switch. Water should start flowing through the jets. Use the air-enrichment valve to let the desired
amount of air into the water to fine-tune the optimal water-air mixture (The more air you add to the water jets, the
more forceful the massage becomes).
Start with a short massage and gradually adjust the duration.
This will focus the massage potential of the water to the open jets. Please note that closing all the jets and obstruct-
ing water flow may lead to the engine overheating the function switching off.
Turn off the massage system before getting out of the bathtub - the water level may have dropped due to overflow,
meaning that the water may not cover the uppermost jet!
Warnings
1. The motor is protected against overload by a thermal cutout (so-called klixon).
2. Switch off the main power switch before performing any repairs, adjustments or cleaning.
3. Filtering of the water must be ensured! Faucets with ceramic are very sensitive to small impurities found in drink-
ing water, such as sand, metal shavings, etc.
4. Cardiac patients, people with hypertension and people with poor overall health should consult their doctor be-
fore using the product.
5. A young child under 14 years of age may only use and operate products equipped with a hydromassage system
under parental supervision. Wellis Magyarország Ltd is not liable for any claims whatsoever arising from improp-
er use.
6. If you are under the influence of alcohol or drugs, hot water can cause loss of consciousness!
23