For Bathtubs Installed Along With Electrical Equipment; Installing The Product; Planning And Preparation; Bathtub Installation Procedure - Aqua Nova Wellis Notice D'utilisation

For bathtubs installed along with electrical equipment

Before using the product check your residual current device (FI) by pushing its dedicated test button. The user must
inspect the electrical wiring at least every 3 months. A similar inspection should be carried out by a qualified profes-
sional every 3 years. If you notice any irregularities, immediately contact a professional. The residual current device
switch cannot be in the same room as the bathtub!
The main fuses/circuit breakers activate when a power failure occurs.
Before performing maintenance on electrical components disconnect the massage pool from the power supply (Such
procedures may only be performed by qualified professionals).
The installation of the bathtub and its wiring, the replacement of cords, and any repairs must be carried out by qual-
ified professionals. Connections must circuit protected and inaccessible. The sizing and length of the power supply
cables of the product must be planned and inspected.
The electrical installation must be done in accordance with local regulations.

INSTALLING THE PRODUCT

Planning and preparation

The location for the installation of the product must be planned with respect to future use. When selecting the
location ensure that the product can be properly installed and, if needed (after making a warranty claim), properly
removed. Removability and movability are installation requirements. If the product is not installed with respect to
these factors, the warranty does not cover related removal and rebuilding expenses. For sunken bathtubs vertical
movability and physical access to the area under the tub (via maintenance hatch or door) must be ensured. Please
contact a qualified professional to ensure proper installation.
Every bathtub must be provided with adequate drainage (min. 50 mm), proper tilting, and connection to hot and cold
water. Refer to the connection diagram of the product.
For bathtubs without hydraulic or electrical accessories (hereinafter referred to as: Empty bathtub) use of the lev-
el-stand purchasable for the product is obligatory. All other products (standing bathtubs, bathtubs with hydraulic
systems) are self-supporting and do not need additional support.
The attachable front and side covers available for bathtubs with hydraulic systems provide access to the mechanical
components of the product.
In case of a malfunction the bathtub may leak large amounts of water. To avoid damages proper floor drainage must
be installed in the room where the product is located! We accept no liability for damages due to improper drainage,
as per article 340.§ (1) of the Civil Code of Hungary.
The area under the bathtub must be a waterproof, level surface. Water protection for the bathtub area is mandatory;
water protection for the whole room is recommended. Tiles and glazed tiles with joints are not watertight in and by
themselves. We recommend covering the level floor and the walls with liquid film.
It is advisable to cover the area beneath the (hydro massage) bathtub as well!
If the tiling does not reach the flooring, the tiles must be 150 - 200 mm below the bathtub's flanges! The flooring must
reach 150 - 200 mm below the bathtub from the front cover!
Using underfloor heating under the bathtub is prohibited!

Bathtub installation procedure

The (hydro massage) bathtub must not be damaged during the installation! It is advisable to cover the inner surface
of the bathtub until it is set up!
The 'empty' bathtub surface is covered by a protective film!
Do not lift the bathtub by the fixtures or piping!
For certain types of product it is also prohibited to lift the bathtub by the ornamental frames or the glass parts!
Electrical connections, odor control syphon outputs, faucets (optional) must be accessible from the maintenance hatch!
21