Operating The Pneumatic Start Buttons (For Hydro System); Operating The E-Drive, E-Max - Aqua Nova Wellis Notice D'utilisation

7. Do not stay in the bath for a prolonged period during pregnancy because hot water can damage your baby's
health! You may stay up to 10 minutes in the tub at a time!
8. Never place any operating electrical equipment within the 2 metre radius of the bath!

Operating the pneumatic start buttons (for Hydro system)

If your hydro massage bath does not have an electrical control system, then, in accordance with your configuration,
you will find one (Hydro) start buttons on the flange of the bathtub. The buttons are used for the control of the mas-
sage and bubble bath functions. A single push of the button starts the function, the second push shuts it down.
For both systems turning the air-enrichment valve located on the flange of the bathtub will boost the massage func-
tion by letting more air into the system.

Operating the E-Drive, E-Max

If your hydro massage bathtub is equipped with an E-Drive, E-Max Touch and E-Multimedia Touch system you will see
the control unit pictured below. Use the 4 buttons of the control unit to control the product's functions.
The lower row of the display features the bathtub's function icons:
Radio
Hydro massage
Using the control unit's buttons the bathtub functions can be adjusted as per the following. If you do not use the unit,
it automatically locks its buttons. It can be unlocked by pushing and holding the OK button.
The control buttons
Power button
Push the button to turn the system on. Push and hold the button for 3 seconds to turn the system off. Both proce-
dures are followed by an audio prompt.
Function button
Push the button to turn the selected function on. Push and hold the button for 3 seconds to turn it off.
24
Ozone generator
Water heating function
Lighting
Bubble bath function