Napoleon Ascent BX42 Manuel D'installation page 51

note:
• Electronic appliance temperatures must be validated at the time of installation as air fl ow
characteristics within the room can vary and maximum acceptable operating temperatures can vary from
appliance to appliance. Electronic appliances cannot be used where the electronic appliance temperature
exceeds the manufacturer's maximum allowable operating temperatures (see electronic appliance
manufacturer's specifi cations). Operating a television above the manufacturer's maximum allowable
operating temperature will result in premature failure.
• Mantel height and depth must conform to mantel clearance requirements specifi ed in this manual, see
"minimum clearance to combustible mantel" section in installation manual.
• Electronic appliance temperatures may be further reduced by increasing the horizontal distance between
the front of the electronic appliance and the front edge of the mantel or by increasing dimension "A" or "B".
However, increasing the gap between the top of the mantel and the bottom of the electronic appliance
beyond the maximum recommended fi gure, typically results in higher temperatures. Minimum clearance
between the mantel and bottom of the electronic appliance should be maintained to allow air circulation
below and behind the electronic appliance.
10.7 air fl ow cover installation
Install one air fl ow cover at each end of the burner stiffener rail (2 total)
using 4 screws (supplied).
note:
The air fl ow covers must be installed.
fi nishing
EN
51
W415-2920 / B / 04.26.22