iKarus Rumpler Taube Notice De Montage page 18

18.) Using the stencil/pattern you have to cut an opening into the fuselage nose for the motor
installation.
19.) Use a pair of scissors to cut out the 4 ABS landing gear straps. Attach them with the screws
(included in kit) to the plywood landing gear support strips on the fuselage bottom. Push the wheels onto
the axles and secure them with the wheel collars (1.5mm).
Attach the tail skid with 5 min. epoxy to the underside of the fuselage tail.
straps
20.) Attach the horizontal stabilizer to the stabilizer base (use styrofoam glue). Make sure that it is centered
and that you can see the seam of the monocoque through the holes in the stabilizer. Now you can glue the
vertical stabilizer into the slots. Be sure the horizontal and vertical stabilizer form a right angle. Reinforce the
fuselage tail in the rudder area with two strips of selfadhesive tape.
tail skid
All manuals and user guides at all-guides.com
7
here you can see
the sean of the fuselage
horizontal stabilizer