iKarus Rumpler Taube Notice De Montage page 16

All manuals and user guides at all-guides.com
Landing gear
10) The wheel centers are marked .
There you have to drill a hole of 3-4 mm(1/8 in)
In the hubs you have to drill a hole of 1.6 mm(1/16 in)
Glue the hubs into the wheels, using solvent free epoxy glue.
drill here
hubs
collar
11.) Connect the two landing gear wires, with the (3mm) collars.
plywood support strips
12.) Glue the two plywood strips into the corresponding position
at the fuselage bottom. They will carry the landing gear.
13.) Cut off the fuselage top along the marked lines, using a
sharp knife. Cut out the sides of the fuselage to allow the wing
to fit . The open fuselage allows you now to check whether the
parts have been successfully glued together.
marked lines
14.) Now you have to adjust the position of the wing to be top
centered and perpendicular to the fuselage. Then you have to
attach the top of the fuselage to the wing. Be sure it lines up
straight.
fuselage
5