iKarus Rumpler Taube Notice De Montage page 17

All manuals and user guides at all-guides.com
formers
wing attachement
cut off here
mark here
15.) Glue the two formers together and then glue them into
the top fuselage. Half of it should be inside, half outside. The
outside former will interconnect with the fuselage.
16.) Cut an opening of about 20 x 20 mm (6/8 x 6/8 in.) into the
cut-off fuselage top, to give access to the wing mounting screw.
17.) Place the wing on the fuselage again and mark the position for
the screw/nut.Take the wing off again and drill a hole of 5mm (3/16
in.) diameter and a depth of 10 mm (3/8 in.) into the wing carrier.
Afterwards you have to glue the captive nut with CA glue in
position.
6
captive nut
front wing attachment
and motor carrier
drill here