iKarus Rumpler Taube Notice De Montage page 14

monocoques
Tail wings
5.) Cut or sand a 30 degree bevel in the rudder/elevator of the tailplane. When this is done attach them using
adhesive tape to hinge the surface as shown.
6.) Cut holes in elevator and rudder ( ¼ " back
from the hinge line). Locate the control arms and
the backers with epoxy. The backers are used to
reinforce the construction.
retainer straps
All manuals and user guides at all-guides.com
selfadhesive tape
fin/stabilisator
stabiisator
Wings
7.) Use a pair of scissors to cut out the wing
joiners.
3
rudder/elevator
bevel 30 degree
<>
Ca. 5mm
control arms
elevator
stopper