Tilt Adjustment - CHIEF iC Serie Instructions D'installation

iC-PTM3 Series
4
5
16
All manuals and user guides at all-guides.com
1
2
3
1
2
Switching Interface Brackets
(Optional)
For wide hole patterns, interface brackets must be
reversed. See Table 1 below to determine if this is
necessary.
Table 1: Hole Pattern Width
Model # normal installation
iCMPTM3 100-440mm
iCLPTM3 200-663mm
iCXPTM3 200-847mm
1. Remove the tilt tension knob, washer and screw
from interface bracket.
IMPORTANT ! : Hold the brackets steady when
removing the knob, washer and screw from
interface bracket to prevent internal washers from
falling out. If internal washers do fall out, they
must be reinserted in proper position before
reinstalling knob on the other side!
2. Replace the knob, washer and screw in the
opposite order.
3. Repeat for the other interface bracket.
4. Install interface brackets according to instructions
in Section 2.

Tilt Adjustment

1. Adjust tilt tension adjustment knobs to desired
tension.
2. Adjust tilt of display by pulling the top of display
away from the wall until desired tilt position is
reached.
3. Tighten tilt tension adjustment knobs to secure tilt
position.
Installation Instructions
swap uprights
441-506mm
664-728.8mm
848-913mm