CHIEF iC Serie Instructions D'installation page 14

iC-PTM3 Series
2
6
(C)
6
(C)
14
All manuals and user guides at all-guides.com
(GA-GO) x4,x6,x8
7
2 4
(GS) x4,x6,x8
5
(non-recessed holes)
7 (GA-GO) x4,x6,x8
2 4
(GS) x 4, x 6, x 8
3
5
(recessed holes)
INSTALL BRACKETS TO DISPLAY
WARNING:
100mm x 100mm for the iCMPTM3 and
200mm x 200mm for the iCLPTM3 and the
iCXPTM3.
(B)
1. Lay display face down on protective surface.
CAUTION:
may damage your display! Proper screws will easily
thread into display mounting holes.
2. Select screw diameter by examining hardware
(GA-GO) (8mm, 6mm, 5mm, or 4mm) and
comparing with mounting holes on display.
3. Select spacers:
• If mounting holes are not recessed and both
brackets (B and C) can lay flat against
display, then no spacers are required.
• If mounting holes are recessed, or if
protrusions prevent brackets (B and C) from
laying flat, then spacers (GP or GQ) must be
used.
CAUTION:
damage your display! Proper screws will have
(B)
adequate thread engagement without contacting
bottom of display mounting holes.
(GP or GQ)
4. Select screw length:
• Using your hand, insert SHORTEST length
screw of selected diameter (GA, GE, GI or
GL) through brackets (B and C), universal
washer (GS), selected spacer (GP or GQ, if
required), into display mounting hole. Do
NOT thread screw into hole at this time.
• Proper screw length requires base of screw
head to protrude above flat washer a distance
equal to or greater than the screw diameter.
If screw length is inadequate, select longer
screw. Select shortest screw which will
protrude the required distance.
5. Place brackets (B and C) on display, ensuring:
• Upper hooks are towards top of display.
• Center of brackets (B and C) are as close to
the center of the back of display as possible
after being installed. Center of bracket is
indicated by the diamond-shaped hole.
6. If installing display with wide hole pattern, it may
be necessary to swap the uprights (B and C). See
Switching Interface Brackets section for details.
7. Using Phillips screwdriver, carefully install
selected screws through universal washers (GS),
brackets (B and C), and spacers (GP or GQ, if
required), into display.
8. Tighten all screws. Ensure all applicable display
mounting holes (4, 6, or 8) are used.
Installation Instructions
The minimum hole pattern size is
Using screws of improper diameter
Using screws of improper length may