CHIEF iC Serie Instructions D'installation page 13

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 42
Installation Instructions
1A
(A)
1
CENTER
LINE
4
(F) x 4 or 6
(E) x 4 or 6
(D) x 4 or 6
5
1/2" (12.7mm)
All manuals and user guides at all-guides.com
(iCMPTM shown)
x 4 or 6
2
x 4 or 6
3
(F) x 4 or 6
(A)
INSTALL WALL PLATE TO WALL -
CONCRETE, CONCRETE BLOCK OR
BRICK
WARNING:
Failure to provide adequate structural
strength for this component can result in serious personal
injury or damage to equipment! It is the installer's
responsibility to make sure the structure to which this
component is attached can support five times the
combined weight of all equipment. Reinforce the
structure as required before installing the component.
WARNING:
ELECTRICAL SHOCK HAZARD!
CUTTING OR DRILLING INTO ELECTRICAL CORDS
OR CABLES CAN CAUSE DEATH OR SERIOUS
PERSONAL INJURY! ALWAYS make certain area behind
mounting surface is free of electrical wires and cables
before drilling or installing fasteners.
WARNING:
EXPLOSION AND FIRE HAZARD!
CUTTING OR DRILLING INTO GAS PLUMBING CAN
CAUSE DEATH OR SERIOUS PERSONAL INJURY!
ALWAYS make certain area behind mounting surface is
free of gas, water, waste, or any other plumbing before
cutting, drilling, or installing fasteners.
1.
Unfold wall plate (A) to prepare it for mounting to wall.
2.
Level wall plate (A) and mark locations of pilot holes at
desired mounting location.
NOTE:
For the iCLPTM3, either the inner or outer four
holes may be used.
NOTE:
For the iCXPTM3, use the outer four holes and the
two middle holes on wall plate for installation.
NOTE:
The vertical center of the display will be even with
the center line indicated on the labels located
directly below each hinge. Keep this in mind when
determining mounting location.
3.
Drill 5/16" (7.9mm) diameter pilot holes into wall at
marked locations. Holes must be drilled at least
2-1/2 inches deep.
4.
Install concrete anchors (F) into drilled holes. Use a
hammer to tap anchors into holes.
5.
Using 1/2" (12.7mm) wrench, install screws (D) through
flat washers (E), wall plate (A) and into concrete
anchors (F).
iC-PTM3 Series
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Icmptm3Iclptm3Icxptm3

Table des Matières