CHIEF iC Serie Instructions D'installation page 12

iC-PTM3 Series
1
(A)
1
3 x 16"
(E) x 4 or 6
(D) x 4 or 6
4
1/2" (12.7mm)
12
All manuals and user guides at all-guides.com
(iCMPTM shown)
x 4 or 6
2
2 x 24"
2 x 16"
(iCXPTM3)
CENTER
LINE
3
x 4 or 6
INSTALL WALL PLATE TO WALL - WOOD
STUDS
WARNING:
Failure to provide adequate structural
strength for this component can result in serious personal
injury or damage to equipment! It is the installer's
responsibility to make sure the structure to which this
component is attached can support five times the
combined weight of all equipment. Reinforce the
structure as required before installing the component.
The wall to which the mount is being attached may have
a maximum drywall thickness of 5/8" (1.6cm).
1. Unfold wall plate (A) to prepare it for mounting to wall.
2. Level wall plate (A) and mark locations of pilot holes.
NOTE:
The iCMPTM3 must be installed on two 16" studs.
The iCLPTM3 can be installed on 16" studs (inner
holes) or 24" studs (outer holes). For the iCXPTM3,
it can be mounted over two or three 16" studs or
two 24" studs. If mounting to three 16" studs, it
must be mounted to all three studs using the outer
holes and center holes.
NOTE:
The vertical center of the display will be even with
the center line indicated on the labels located
directly below each hinge. Keep this in mind when
determining mounting location.
3. Drill 7/32" (5.5mm) diameter pilot holes into wood studs.
4. Using 1/2" (12.7mm) wrench, install screws (D) through
flat washers (E), wall plate (A) and into wood studs.
Installation Instructions