KITE SERIES
Pitch Adjustment
1.
Loosen PITCH adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 7)
2.
Turn PITCH micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
(See Figure 7)
3.
Tighten PITCH adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 7)
2
Figure 7
Roll Adjustment
1.
Loosen ROLL adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 8)
2.
Turn ROLL micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
(See Figure 8)
3.
Tighten ROLL adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 8)
1
Example Only
3
(Interface bracket
varies dependent
on projector model)
Figure 8
8
1
3
2
Height Adjustment
WARNING:
Failure to provide adequate support for this
mount during the height adjustment process can result in
serious personal injury or damage to equipment! It is the
installer's responsibility to make sure the projector is
removed from the mount prior to adjustment and that the
weight of the mount is supported while the height is being
adjusted! Remove the projector from the mount prior to
height adjustment!
1.
Remove projector from mount.
2.
Loosen height adjustment screw. (See Figure 9)
3.
While supporting the weight of the projector mount, adjust
height as desired. (See Figure 9)
4.
Tighten height adjustment screw. (See Figure 9)
5.
Reinstall projector to mount.
2
3
4
height adjustment
screw
projector removed
Figure 9
Installation Instructions