Minimum Dimensions - Samsung NX58H9500W Serie Manuel D'installation

Minimum dimensions

If overhead cabinets are provided, a range hood should also be provided
that projects horizontally a minimum of 5 in (12.7 cm) beyond the front of
WARNING
the cabinets. This will dissipate any heat buildup in the overhead cabinets
to prevent death, personal injury, and/or fire hazard. The ventilating hood
must be constructed of sheet metal not less than 0.0122" thick. Install
above the cooktop with a clearance of not less than 1/4" between the hood
and the underside of the combustible material or metal cabinet. The hood
must be at least as wide as the appliance and centered over the appliance.
Clearance between the cooking surface and the ventilation hood surface
must never be less than 24 inches.
Exception 1 : Installation of a listed microwave oven or cooking appliance
over the cooktop shall conform to the installations packed with that appliance.
• 30-in (101.6-cm) minimum clearance between the top of the cooking
surface and the bottom of an unprotected wood or metal cabinet; or If no
30-in(101.6-cm) minimum clearance, 24-in (61-cm) minimum when the
bottom of the wood or metal cabinet is protected by not less than 0.25-in
(0.64-cm) flame-retardant millboard covered with not less than no. 28
MSG sheet steel, 0.015-in (0.038-cm) stainless steel, 0.024-in (0.061-
cm) aluminum, or 0.020-in (0.051-cm) copper.
• 18-in (45.7-cm) minimum between the countertop and the adjacent
cabinet bottom.
Exception 2 : For island installation, maintain 2-1/2" minimum from cutout
to back edge of countertop and 4" minimum from cutout to side edges of
countertop.
Installation guide
SLIDE-IN CUTOUT
Hatched Faces should be
flat and leveled.
A: Cabinet opening 30" (76.2 cm)
IMPORTANT: If your cabinet have height over 36-4/5", this range cannot be installed
without supporting unit like hard block.
3"
24" 1"min
3"
23 3/16"
25"
35-7/8"
A
English - 19
FREESTANDING CUTOUT
1/2"min
25"
3"
24"
3"
A