Samsung NX58H9500W Serie Manuel D'installation page 33

Step 7. Assemble the surface burners
Do not operate the surface burners without all burner parts in place.
CAUTION
1. Position surface burner heads on top of the surface burner manifolds as
shown at right. The electrodes will fit into the slot in the bottom of the heads.
Make sure the surface burner heads are flat and parallel with the cooktop.
2. Place the matching size caps on top of each surface burner head.
The caps on Precise simmer burner (RR) and inside Dual Burner (RF) can be
interchangeably used.
3. Place the left, center, and right
surface burner grates on the
cooktop. The edges of the grates
should match up with the edges of
the cooktop.
Step 8. Check the ignition of surface burners and oven
burners
Check the operation of all cooktop and oven burners after the range has been
installed and assembled, gas supply lines have been carefully checked for leaks,
and electrical power cord has been plugged in.
All surface and oven burners have electronic ignition.
To turn on a surface burner:
1. Ignite the surface burner
Top
English - 33
Bottom