Base Cover Replacement - Stryker 4810 Manuel D'utilisation Et D'entretien

BASE COVER REPLACEMENT

Tools Required:
• #2 Phillips Screwdriver
• T25 Torx Driver
• T27 Torx Driver
WARNING
To avoid the risk of personal injury or damage to the table, support the table top before removing the screws that secure
it to the upper weldment.
Procedure:
1. While holding the upper column, use a T25 Torx driver and remove the three T25 Torx screws from the top of the
upper column then lower the column down to the base.
2. Using the T27 Torx driver, remove the two opposing T27 Torx screws that connect the upper bushing to the lower
column.
3. Lift the top assembly straight up and out of the lower column and set it aside.
4. Lift the upper column off the lower column and remove it from the base.
NOTE: It is easier to perform the next step while sitting on a chair.
5. Flip the base and lower column over and rest the lower column on the top of your thigh.
6. Using the T27 Torx driver, remove the four T27 Torx screws from the bottom of the base that hold the column
assembly and remove the lower column.
7. Turn the base and cover over. Using the Phillips screwdriver, remove the six #8 Phillips screws that hold the cover
to the base.
8. Turn the base back over and remove the cover.
9. Reverse steps to reinstall.
10. Verify proper operation of the unit before returning it to service.
www.stryker.com
Service Information
4810-009-001 REV C
Return To Table of Contents
1-17
English