Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7
Cutting procedure
During cutting, place the blade
guard as close as possible to the
tile, in order to avoid water
splash.
J
F
H
• Straight cuts
- Slacken the two wing nuts (F).
- Fit the straight cutting guide (G).
- Set the guide to the desired size.
- Tighten the two wing nuts (F).
• Diagonal cuts
- Position the tool (J) along the cutting
guide (G).
- Slacken the two wing nuts (F).
- Set the cutting guide (G) to the
distance required.
- Tighten the nuts (F).
• Bevel cuts
- Loosen (H).
- Tilt the table to required angle (from
90 to 45°).
- Relock (H).
- Adjust the cutting guide as for straight
cuts.
• Pass the material slowly and without
force, through the diamond blade.
• This will ensure a greater lifetime of the
blade and avoid overheating of the
motor.
Never cut dry. Check frequently
the water level through the
overflow (change water as often
as necessary)
• After each use, stop the machine by
means of the on - off switch.
8
Maintenance
• Empty the water bath.
• Clean the machine every day, make sure
the water compartment is clean.
• Store your machine in a dry area.
G
Store in a safe place
Maintain tools carefully
FIG. 2
9
Important advice
• Tighten all the nuts and bolts regularly.
• Check that there is sufficient water
supply during operation.
• Tighten the blade firmly.
• A plastic/polypropylene water tray is
recommended.
The manufacturer declines all
responsibility for loss or damage
resulting from misuse or any
modification,
powering that does not conform
to the manufacturer's original
specifications.
At the work station, the sound
pressure level may exceed 85 db
(A)
In this case individual protection
measures must be taken.
10
Repairs
Contact your supplier who is
S
entirely at your service to carry
A
V
out repairs in the shortest time at
the best possible price.
11
(machine disconnected)
For rapid delivery of spares and in order to
avoid any wasted time, it is necessary to
remind your supplier of the details shown
on the instruction plate on the machine with
each order, as well as the reference of the
part to be replaced.
Item number
12
• Main materials :
- Motor : Aluminium (AL) - Steel (AC),
alteration
or
- Machine : Steel sheet (AC) - Inox
The instructions for use and spare parts found in
this document are for information only and are not
binding.
As part of our product quality improvement policy,
we reserve the right to make any and all technical
modifications without prior notice.
Spare parts
00000000
(0)
Quantity
See exploded view
Scrapping
In the event of deterioration and
scrapping of the machine, the
following
items
must
disposed of in accordance with
the
requirements
of
legislation in force.
Motor :
Copper (CU) - Polyamide (PA)
be
the
8
Publicité
Table des Matières
