Heidolph Hei-FLOW Core Notice D'instructions page 82

Attachments
Pump head SP standard
To mount tubes on the SP standard pump head, proceed as follows:
➜ Remove the protector from the pump
head.
➜
Remove the clamping lever.
➜ Insert the tube into the pump head.
➜ Turn the pump head rotor in such a
way that the inserted tube is prefixed
between the rotor and the housing
(see illustration, several turns may be
necessary!).
➜
Mount the clamping lever.
➜ Slightly tighten the inserted tube: Pull
on both ends with moderate force.
➜
Pre-tensioning increases the service
life of the tube and ensures maximum
operational reliability.
➜
Mount the protector.
➜ Perform a short test run before
commissioning to ensure continuity of
the mounted tube.
83