Heidolph Hei-FLOW Core Notice D'instructions page 81

Attachments
Installation of multi-channel pump head C 4 + C 12
The procedure for mounting type C 4 and C 12 multi-channel pump heads is the same
as for mounting type C8 multi-channel pump heads, see section „Mounting multi-
channel pump heads C 8" auf Seite 81.
However, multi-channel pump heads of types C 4 and C 12 are mounted without sleeve,
as this is not required on these models!
Mounting tubes
When mounting the tubes, observe all general instructions as well as specific safety
instructions given in this chapter. For detailed information on tube selection, see section
„" auf Seite 85.
CAUTION
Risk of crushing, possible damage to the device
➜
➜
➜
➜
➜
➜
When removing/mounting the tubes, observe all relevant safety
regulations for mechanical activities to avoid injury to hands
and fingers.
Always disconnect the device from the mains before installing
the tube(s) to avoid injury and/or damage to property due to
an unintended pump start!
Avoid excessive force when mounting the tube(s): All
adjustment and fastening elements must be operated with
manual force only.
Only dismantle protective and/or safety devices where
necessary and exclusively for the purpose of removing/
mounting components and re-assemble them properly after the
work has been completed.
Before switching on the device, make sure that all protective
and/or safety devices are properly mounted.
Check that all cassettes and tubes are securely seated before
starting the pump.
82