Heidolph Hei-FLOW Core Notice D'instructions page 76

Attachments
Mounting pump heads
When installing the pump heads, observe all general instructions as well as all specific
safety instructions given in this chapter
CAUTION
Risk of crushing
➜
➜
➜
➜
Proceed as described in the following sections to remove/mount the pump head.
Pump heads SP standard and SP vario
The SP standard and SP vario pump heads are mounted to the pump housing using the
supplied flange.
Scope of delivery
When removing/mounting the pump head, observe all relevant
safety regulations for mechanical activities to avoid injury to
hands and fingers.
Always disconnect the device from the mains before removing/
mounting the pump head to avoid unintended start-up!
Only dismantle protective and/or safety devices where
necessary and exclusively for the purpose of removing/
mounting components and re-assemble them properly after the
work has been completed.
Before switching on the device, make sure that all protective
and/or safety devices are properly mounted.
77