Unpacking And Placement; Unpacking Your Cd Player; Important; Custom Installations - Classe CDP-100 Manuel Du Propriétaire

unpacking your CD player Carefully unpack your CD player according to the supplied instructions, and remove all

Important!

placement As with any digital component, it is best to place the CDP-100 somewhat apart
ventilation Your Classé CD player generates a certain amount of heat in the course of normal
custom installations Drawings are included in this manual to facilitate special installations and custom
serial number The serial number for your CD player is found on the rear of the unit. Please note and
register your purchase! Having found the serial number, now would be a good time to fill out the registration
operating voltage The CDP-100 CD player is set at the factory (internally) for 100V, 120V, 230V, or
6
All manuals and user guides at all-guides.com

Unpacking and Placement

accessories from the carton.
Keep all packing materials for future transport of your Classé product.
Shipping your new component in anything other than its purpose-
designed packing material may result in damage that is not covered
by the warranty.
from your most sensitive analog electronics, particularly turntables and preamplifiers.
Generally, placing it on its own shelf should suffice.
Note that adequate clearance for the AC cord and connecting cables must be
left behind the CDP-100. We suggest leaving eight inches (20 cm) of free space
behind your CD player to allow all cables sufficient room to bend without
crimping or undue strain.
Classé recommends that the unit not be placed directly on the top surface of a power
amplifier (or any other heat source).
operation. Be sure to allow three inches of clearance above it and three inches to each
side to allow heat dissipation through air circulation. Avoid placement on soft surfaces
that would restrict airflow (such as plush carpeting).
cabinetry (see the section Dimensions). An optional, purpose-designed rack mount kit is
available for this product. Contact your Classé dealer for more information.
record this number on the page entitled Important Safety Instructions for your future
reference.
card. Please register your purchase so we can advise you of updates and other items of
interest.
It will take only a minute or so. Please complete the card now, before you forget.
240V AC mains operation, as appropriate for the country in which it is to be sold.
(230V only in European Union countries, in compliance with CE regulations.) The
voltage setting may not be changed by the user.
Make sure that the label on the rear panel of your CD player indicates the correct
AC operating voltage for your location. Attempting to operate your CD player at an
incorrect voltage may damage the unit.