Front Panel; Menu Button - Classe CDP-100 Manuel Du Propriétaire

10
All manuals and user guides at all-guides.com

Front Panel

1 Standby button & LED indicator
The front panel Standby button will toggle the player between its fully operational
status and a standby mode that leaves the player off, yet ready to respond to system
commands via any of the supported control options (e.g. IR input, DC trigger,
CAN Bus, or RS-232).
The current state of the player is indicated by the LED on the Standby button on
the front panel. When the unit is powered and switched on, this LED indicates
the following:
• on
• flashing (on power-up)
• off
• on (dim)
• flashing (after power-up)
If you are not going to use the player for an extended period of time, e.g. vacation
or other travel, we suggest you disconnect it from the AC mains. Please be certain
that the player is in standby prior to disconnecting it from the AC mains.
Also, it is a good practice to physically disconnect any and all valuable electronics
from the AC mains during electrical storms, as a lightning strike anywhere near
your home can put a tremendous surge on the AC mains that will easily damage
any piece of electronics, no matter how well designed and protected. The best
protection in the case of severe electrical storms is simply to remove the electronics
from any connection with the power grid.
2

Menu button

Pressing the front panel Menu button will call up the menu system, replacing the
normal status display in the LCD touchscreen of the CDP-100.
= standby
= initialization
= operate
= display timeout
= AC mains voltage out of range