Classe CDP-100 Manuel Du Propriétaire page 14

Danger!
14
All manuals and user guides at all-guides.com
5 DC Trigger Input and Output
Many audio/video components can supply a DC control voltage to associated
equipment in order to induce desired behavior. Your Classé player can take
advantage of these capabilities in order to be switched between operate and standby
automatically, usually in concert with the A/V preamp itself.
The 1/8th-inch mini-jack Trigger In is for remote-controlled turn-on (that is,
toggling between operate and standby) of the player.
Two 1/8th-inch mini-jacks provide individually controllable DC trigger outputs
which can be used for any of a number of purposes, as described in The Menu
System. For example, your dealer can program Trigger Out1 to toggle your Classé
power amplifier between operate and standby with your CDP-100.
The remote Trigger In will respond to the presence of 5–12VDC, with tip
polarity as shown below:
Similarly, Trigger Out will create a 12VDC signal that can source up to 100mA of
current.
6 Classé CAN Bus Control Ports
These RJ-45 connectors are reserved for future control and communication
applications using Classé Audio's implementation of the Controller Area Network
(CAN) Bus specification.
7 RS-232 Control Port
This DB-9 connector has two purposes:
• downloading new operating software into your player
• external control of your preamplifier by systems such as i-Command™,
AMX and Crestron™
®
For more information, please contact your dealer and ask about home automation
systems.
8 AC Mains Power switch
The main power switch for the CDP-100 is located at the right side of the rear
panel. The player should be in standby mode before being switched off. Switching
the unit on puts it in standby mode.
Potentially dangerous voltages and current capabilities exist within
your CD player, even when disconnected from AC mains. Do not
attempt to open any portion of the player's cabinet. There are no
user-serviceable parts inside your CD player. All service of this
product must be referred to a qualified authorized Classé dealer or
distributor.
9 AC Mains Input
An IEC standard power cord (supplied) is used with the CDP-100. Plug the cord
into the IEC outlet provided, and the other end into a suitable wall outlet.