•
Electrical Installation
Connect up the heater according to the circuit dia-
gram on page 36. The right hand side panel can be
removed in order to provide better access to the
connection cabinet. To do this, remove the lower
plastic cap and screw. Pull the side panel about
1cm outwards and backwards and take it away
sideways.
No internal wiring, nor the wires of the power-
supply cables should be reachable from outside
through the ventilation slits in the side panel.
•
Element ratings
The heater is factory wired for maximum power
draw (100%).
For a lower current draw, remove the correspond-
ing jumpers on the „N" according to the circuit dia-
gram.
Cover up the non-applicable power ratings on the
heater rating label (bottom right of heater) with the
label provided (provided in the bag with the wall
mounting materials) - see example of rating label
on page 36. For this, remove the protective paper
from the adhesive side of the label. Position the
adhesive side on the power rating to be covered by
means of the frame-outline printed on the rating la-
bel. Press the covering label firmly and then re-
move the carrier foil. Proceed in the same way for
the second rating to be covered.
Tip: To facilitate this either cut out the appropriate
labels before or unscrew and remove the fas-
cia plate with the rating label.
Put a cross against the chosen rating in the circuit
diagrams, both in the Instruction Leaflet, and in the
front panel.
•
Close the heater back up (Fig.16 - 17):
26. Offer up the cover plate in an almost horizon-
tal position with the bevelled edges left and
right to the bottom of the inner cabinet (E). Set
the lower edge of the cover plate into the slot
between the floor insulation and the forward
edge of the floor plate.
27. Tilt the cover plate upwards and, slightly lifting
the plate on the right and left side, hang it
onto the fixing screws.
All manuals and user guides at all-guides.com
27.
E
Fig.16 Inserting the cover plate
26.
33