Connecting The Power Supply; Operation - Renkforce TP-1000 Notice D'emploi

Connecting the power supply

Make sure that, before you connect device to the power supply grid, the operating mode switch
(1) is switched off (position "OFF").
The POWER (1) switch does not entirely disconnect the device from the electricity supply. In
order to completely separate the device from the electricity net, you have to pull the mains plug
out of the wall socket.
• Connect the mains plug of the cassette recorder to a socket (230V~/50Hz) linked to the public power supply
network.

Operation

1 2
FW D
A
PLAY
PO WE R
ON O FF
PLAY R EW
7
(1) POWER button
This button switches the Cassette recorder on and off.
Position ON > Device is on, alternatively in standby mode (when switched off by the amplifier A-1000 remote
control) , Position OFF > Device is switched off.
(2) Cassette drives
Please put the cassette into the recorder. The device has two drives, deck A is for playing, deck B is for playing
and recording.
(3) Switch NOISE REDUCTION
Use this switch (shift it to ON) to activate the dynamic hissing rejection system.
All manuals and user guides at all-guides.com
3 4
LEVEL M ET ER IN DIC AT ION
N OIS E R EDUC TION
DY N AM IC N O IS E RED UC TION
F U LL AUTO ST OP SYSTEM OF F ON
PLAY C rO 2 D UBBIN G
FF STOP/EJ. PA USE
11 10
5 6 2
DEC K B C O UN TER
RE C LEVEL
FWD
B
RE C /P LAY
MI N MAX
H I.SP.DU B. RE C CrO2
RE C PLAY REW
9 8 7
HIGH S PEED DU BBIN G
FU LL AUT O ST OP SY STEM
FF STOP/EJ. PAUSE
25