Connection Of The Cinch Sockets; Connecting The Power Supply; Connecting The Usb Cable - Renkforce TP-1010USB Mode D'emploi

a) Connection of the Cinch Sockets
For the connection of the cinch sockets only use the shielded cinch wires. Use of any other cables
may cause interferences.
To avoid distortions or mal-adjustments that may cause damage to the device, only such devices
must be connected to the cinch sockets that also have cinch connections.
• Connect the LINE PLAY/OUT to the TAPE input of your amplifier (usually marked TAPE IN or TAPE PLAY).
• Connect the LINE REC/IN to the TAPE output of your amplifier (usually marked TAPE OUT or TAPE REC).
Connect the white cinch socket to the let cinch connection of the amplifier.
Connect the red cinch socket to the right cinch connection of the amplifier.
b) Connecting the Power Supply
Before plugging in the mains plug, ensure that the device voltage indicated at the device cor-
responds to the available mains voltage. Do not connect the device if the indication does not cor-
respond to the available mains voltage. The wrong supply voltage will cause serious damage.
Be careful when handling mains cables and mains connections. Mains voltage may cause poten-
tially fatal electric shock.
The mains socket to which the device is connected must be easily accessible so that it can be
quickly separated from the mains voltage in case of an error.
The cassette deck and all connected devices must be switched off when the power supply is con-
nected.
Make sure that no cables lie around openly. Install cables professionally to prevent accidents.
Make sure that all electrical connections and connection cables between the different devices and
any extension cables comply with the regulations and the operating instructions. If an extension
line is used, ensure that it is designed for the respective load.
• Connect the mains plug of the cassette deck to a socket (220 - 240 V/50 Hz) of the public mains supply.
c) Connecting the USB Cable
The USB output of the cassette deck is only intended for direct connection to your computer. No
other USB device, such as a USB hard disc, USB hub, USB charger, etc. must be connected to the
USB output of the cassette deck.
• Start the computer and switch on the cassette deck. Connect the USB connection of the cassette deck to a free
USB port of your computer. Use the enclosed USB cable. The corresponding device drivers are usually installed
automatically.
23