Play A Cassette; Fast-Forward And Rewind - Renkforce TP-1000 Notice D'emploi

Play a cassette

• Playing cassettes is possible in both decks (A and B).
• Press the key POWER (1) to switch on the device.
• Press the / STOP/EJ button. The cassette compartment (2) opens.
• Put a recorded Cassette with tape opening downwards in the drive.
• Close the drive.
• Select the Tape-input on your amplifier.
• If it is a CrO -Cassette, press the button PLAY CrO
2
on the display (4) above the button.
• Put the switch NOISE REDUCTION (3) into the correct position for this cassette.
The cassette was recorded with the hissing reject system > put switch to ON.
The cassette was recorded without the hissing reject system > put switch to OFF.
• Press the key  PLAY.
• The playing starts.
• Press the button  PAUSE to interrupt the replay shortly. To continue replay press button  PAUSE again.
• Press the button / STOP/EJ once, to stop the replay.
• Press the button / STOP/EJ again, to remove the cassette.

The replay ends automatically when the tape ends.

Fast-forward and rewind

• Before you can forward or rewind the cassette, you must end the replay with the button / STOP/EJ.
• Press this key  FF to forward the cassette.
• Press this key  REW to rewind the cassette.
• Press the button / STOP/EJ, to stop the forwarding or rewinding.
• On deck B you can check the tape position with the tape counter (5).

The forwarding and rewinding ends automatically, when the tape ends.
All manuals and user guides at all-guides.com
(11). When the button is activated agreen control LED flashes
2
27