Cleaning And Storing; After Every Use - SilverCrest SFAV 3.7 A1 Mode D'emploi

All manuals and user guides at all-guides.com
Moistening the cleaning pad
The water outlet openings 14 are located
on the underside of the sole 8. The cleaning
pad 9 is moistened through these openings.
1. Press the moisture button
moisture indicator 4 is lit green as long
as the cleaning pad 9 is being damp-
ened.
2. After a few seconds the moisture indica-
tor 4 goes out again and the process is
stopped.
3. Press the moisture button
ly until the cleaning pad 9 has the de-
sired level of dampness.
Cleaning windows or other
surfaces
WARNING! Risk of material dam-
age!
Do not use the window cleaner on sensi-
tive surfaces that can be easily
scratched.
1. Press the on/off switch 6 to switch on
the vibration of the sole 8. The power
and charging indicator 7 is lit green.
2. Hold the window cleaner with the clean-
ing pad 9 against the surface you wish
to clean while making circular move-
ments to clean it.
3. If the cleaning pad 9 becomes too dry,
press the moisture button
continue cleaning while doing so.
NOTES:
• For stubborn dirt, allow the moisture to
soak in briefly and then clean the area
again.
• The battery must be charged if the power
and charging indicator 7 is flashing red.
4. To stop cleaning, press the on/off
switch 6. The sole 8 stops vibrating
and the power and charging indica-
tor 7 goes out.
5. Wipe the cleaned surface with a squee-
gee or dry with a cotton cloth or cham-
ois leather.
5. The

8. Cleaning and storing

Pull the power unit 10 out of the wall
socket before you clean the device.
5 repeated-
Never immerse the device in water.
WARNING! Risk of material dam-
age!
Do not use any astringent or abrasive
cleaning agents.
NOTE: after each use, pour out the remain-
ing water from the water tank 11 and store
the device with the lid open 1. This prevents
the formation of mould and germs in the de-
vice.

After every use

1. Pour any remaining water from the wa-
ter tank 11 through the filling open-
ing 15.
2. If you had added detergent or glass
cleaner to the water:
5. You can
3. Remove the cleaning pad 9 from the
sole 8, wash it and wring it out.
4. Wipe the housing of the window clean-
er with a damp cloth.
5. Wipe the power unit 10 with a dry, soft
cloth.
6. Leave the lid 1 open and let all parts
dry completely before putting them
away.
DANGER! Risk of electric
shock!
- Rinse the water tank 11 with clear
water.
- Pour clear water into the water
tank 11.
- Press the moisture button
times to flush the system.
- Pour out the remaining water.
5 several
21
GB