Connecting The Units; Connecting The Power Cord - Pioneer AVH-P6600DVD Manuel D'installation

Connecting the Units

Connecting the power cord

Note:
Depending on the kind of vehicle, the
function of 3* and 5* may be different.
In this case, be sure to connect 2* to 5*
and 4* to 3*.
1*
3*
5*
C a p ( 1 * )
When not using this terminal,
do not remove the cap.
Yellow (3*)
Back-up
(or accessory)
Red (5*)
Accessory
(or back-up)
ISO connector
Note:
In some vehicles, the ISO connector
may be divided into two. In this case,
be sure to connect to both connectors.
When you connect separately sold multi-channel
processor (DEQ-P6600) to this unit, do not
connect anything to the speaker leads and system
remote control (blue/white).
3
IP-BUS input (Blue)
IP-BUS cable
2*
4*
Yellow (2*)
To terminal always supplied
with power regardless of
ignition switch position.
Red (4*)
To electric terminal controlled
by ignition switch (12 V DC)
ON/OFF.
Orange/white
To lighting switch terminal.
Black (ground)
To vehicle (metal) body.
15 cm
This product
Multi-CD player
(sold separately)
Connect leads of the same
color to each other.
Fuse holder
Fuse resistor
Fuse resistor
Speaker leads
Front left +
White:
White/black: Front left ≠
Front right +
Gray:
Gray/black: Front right ≠
Rear left + or Subwoofer +
Green:
Green/black: Rear left ≠ or Subwoofer ≠
Rear right + or Subwoofer +
Violet:
Violet/black: Rear right ≠ or Subwoofer ≠
Black
Violet