Industrial LuNAR DT AM Grade 3 Configuration Options
The Industrial LuNAR DT AM Grade 3 can be configured and/or diagnosed remotely via one of the
options:
ACT Mode
LEDs
MW Sensitivity
Diagnostics
Status/Trouble/Info Reports
AM Diagnostics
MW Bypass
MW Disable on Disarm
("Green Line")
LED Display
The three Tri color LEDs in the Industrial LuNAR DT AM Grade 3, operate as herein described:
LED
Steady
Red
Flashing with low frequency
Flashing with high frequency
Steady
Green
Flashing
Steady
Orange
Flashing
All LEDs
Flashing with change of color
Manual
configuration
(
by trimmer)
STATE
Industrial LuNAR DT AM Grade 3 Installation Guide
Remote
Control
Device
-
-
-
-
-
-
-
-
MEANING
Detector alarm (simultaneous PIR and MW
detection)
Indicates malfunctioned communication
with ProSYS
AM detection
Microwave detection
Trouble in the MW channel
PIR detection
Trouble in the PIR channel
Upon power up
ProSYS Bus
Control
5