RISCO Group LuNAR DT AM Grade 3 Guide D'installation page 13

Insert the cable via the cable opening (Figure 4) and connect the desired wires as described in
"Step 4- Wiring".
FIGURE 4
Mount the rear cover in its final location (Figure 5) using the 3 mounting screws and seal the
remaining open holes with sealant.
Return the PCB to its previous location and verify that it is well secured by the holding clips and the
screw.
NOTE:
When a single gang box is used, use 2 additional
screws to mount the base to the single gang box.
The back tamper cannot be used in this case!
FIGURE -5
Back
Tamper
Hole
Industrial LuNAR DT AM Grade 3 Installation Guide
11