Power Fist 8197824 Guide De L'utilisateur page 8

2
Remove the wheels and the
front support leg.
4
Add the support legs. With assistance,
mount the logsplitter to the stand.
Secure all hardware properly.
3
Assemble the base of the
stand as shown.
BLEED SCREW
Before operating the log splitter, loosen the
bleed screw by a few rotations until air can go
in and out of the oil tank smoothly.
Air flow through the Bleed Screw hole should be
detectable during operation of the log splitter.
Before moving the log splitter, make sure the
Bleed Screw is tightened to avoid oil leaking
from this point.
FAILURE TO LOOSEN THE BLEED
SCREW WILL KEEP THE SEALED
AIR IN THE HYDRAULIC SYSTEM
COMPRESSED AFTER BEING
DECOMPRESSED. CONTINUOUS
AIR COMPRESSION AND
DECOMPRESSION WILL BLOW
OUT THE SEALS OF THE
HYDRAULIC SYSTEM AND CAUSE
PERMANENT DAMAGE TO THE
LOG SPLITTER.
8