HumanTechnik signolux Mode D'emploi page 15

5. Inserting the batteries into the
»signolux« receiver
a) At the rear side there is a battery com-
partment the cover of which can care-
fully be pushed downwards so that the
compartment opens ( fig. 5).
Figure 5: Battery compartment of the
»signolux« receiver
b) Now insert 4 alkaline batteries type LR14
(also called C batteries, not included
in the delivery scope). Ensure correct
polarity of the batteries.
c) Close again the battery cover by care-
fully inserting the cover and pushing it
upwards.
Setting and programming
Figure 6: »signolux« top side
6. Setting the signal mode
Using the signal mode slide switch (in fig. 6
"0 1 2") you can select the signal mode.
All manuals and user guides at all-guides.com
0 1 2
Kindly keep in mind that the symbols are al-
ways displayed with coloured light diodes.
– switch to position 0:
signal tone, no flash,
– switch to position 1:
signal tones and flash
– switch to position 2:
no signal tones, flash only
7. Setting the volume
The front side of the »signolux« is protected
by a screen that can be pushed upwards
after loosening the lock on the top side of
the »signolux«. Behind it you will find the
rotating volume control with which you can
set the volume of the signal tone.
Safety guidelines:
Kindly select a lower volume to begin with
and only then set the desired volume.
8. Setting the melody
You can adapt the melody for each symbol:
a) First trigger a signal (e.g. operate door-
bell pushbutton).
b) The symbol assigned to the transmit-
ter should illuminate and the previously
chosen melody should be heard.
c) Wait until the symbol flashes.
d) Press the melody setting button ♫ (fig. 6)
until you have found the desired melody
(you can choose from 15 melodies).
e) Once the symbol ceases to flash, the
selected melody has been assigned.
English 15